Maintenance method of intelligent sewing machine

Source: Time:2018-11-30 16:47:45 frequency:

Maintenance method of intelligent sewing machine:
The application of the intelligent sewing machine needs to be sorted out and lubricated to ensure the normal operation of the machine.
1. Finishing of the sewing machine, finishing of the feed dog, remove the screw between the needle plate and the feed dog, remove the cloth hair and dust, and add a small amount of special oil for the sewing machine.
(2) Finishing of the sewing disc The sewing disc is the core of the sewing machine, and it is also the most prone to problems. Therefore, it is necessary to remove the dirt frequently and use a small amount of special oil for the sewing machine.
(3) Arrangement of other parts The surface dedicated to the sewing machine and all parts in the disk should be cleaned frequently.
2. For the lubrication of intelligent sewing machine, special sewing machine oil must be used. For the sewing machine dedicated to continuous use, the oil should be added once after a day or a few days. If oil is added between applications, the machine should be idling for one rotation time to fully soak the oil and throw out the excess oil, then use a clean soft cloth Wipe the machine head and table top clean to avoid staining the sewing material. Then thread the sewn rags, wipe them with the motion of the seam thread, and throw out excess oil stains until there are no oil stains on the rags, and then formally sew them.
Refueling parts are:
(1) Each oil hole on the machine head lubricates the upper shaft and the components connected to the upper shaft.
(2) The components inside the disc and the moving parts connected to each component. Lubricate the presser foot bar and needle bar and the parts connected to it.
(3) Clean the moving parts of the needle parts and add less oil. Refueling amount of each refueling hole and refueling part need not be too much, one or two drops will do.
Secondly, the maintenance of the sewing machine should also pay attention to the following points:
After the work is completed, insert the needle into the pinhole plate, raise the presser foot, and cover the machine head with the hood to invade people with dust. When starting work, first check the main machine parts, how serious the tread is, whether there are special sounds, whether the needle is normal, etc. If abnormal phenomena are found, they should be repaired in time. After the machine has been used for quite a long time, it needs to be overhauled. If it is found that the parts with greater wear are replaced with new ones.

Product Center
Sewing equipment
Other accessories
About us
About us
cooperative partner
Corporate Style
News
News
Enterprise News
Common problem
contact us
contact us
Message
Tel:0769-83191528 Technical support: yijiantian network
Address: No.568, Shengping Middle Road, Yangwu village, Dalang Town, Dongguan City, Guangdong Province, China Record No:粤ICP备06017439号
official account